|
Blonde Guy
|
 |
« Reply #2 on: 2009.01.13, 18:52:52 » |
|
Thanks, Robert. I have now installed the PCI probe, and it reports four devices using IRQ 11. I've placed them below. How would I change this? I don't see any way to change IRQ used by ServeRaid or Adaptec using either command line parameters, or the configuration programs for the SCSI adpaters in the BIOS.
03:01.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5703X Gigabit Ethernet (rev 02) Subsystem: IBM Unknown device 026f Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 11 Memory at f5000000 (64-bit, non-prefetchable) Capabilities: [40] PCI-X non-bridge device Capabilities: [48] Power Management version 2 Capabilities: [50] Vital Product Data Capabilities: [58] Message Signalled Interrupts: 64bit+ Queue=0/3 Enable-
03:02.0 Token ring network controller: IBM 16/4 Token ring UTP/STP controller (rev 66) Subsystem: IBM Unknown device 0172 Flags: bus master, medium devsel, latency 32, IRQ 11 I/O ports at a000 Memory at f5011000 (32-bit, non-prefetchable) Memory at f5010000 (32-bit, non-prefetchable) Capabilities: [dc] Power Management version 2
04:01.0 RAID bus controller: IBM ServeRAID Controller Subsystem: IBM ServeRAID-5i Flags: bus master, 66MHz, slow devsel, latency 32, IRQ 11 Memory at f0000000 (32-bit, prefetchable) Capabilities: [80] Power Management version 2
04:02.0 SCSI storage controller: Adaptec ASC-29320LP U320 (rev 03) Subsystem: Adaptec Unknown device 0044 Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 11 I/O ports at b000 Memory at f7000000 (64-bit, non-prefetchable) I/O ports at b400 Capabilities: [dc] Power Management version 2 Capabilities: [a0] Message Signalled Interrupts: 64bit+ Queue=0/1 Enable- Capabilities: [94] PCI-X non-bridge device
|