OS2 World Community Forum
OS/2, eCS & ArcaOS - Technical => Setup & Installation => Topic started by: agena on September 13, 2014, 10:01:54 am
-
Hello,
is there a solution to convince eCS to be run in 1366x768 mode ?
vcfgcid /RES:(x):(y):(resolution) /RR:(refresh rate)
fortunately does not allow such experiments. Which is fine.
Alex
-
What video driver are you using, SNAP or Panorama? The resolution you quote appears to that of a laptop, my Acer has 1440 x 900 without problems under SNAP.
-
Hello,
is there a solution to convince eCS to be run in 1366x768 mode ?
Alex
If SNAP: from SNAP dir
gamode add 1366 768 32
-
If the driver is Panorama, it should be simple to set the resolution using Panoutil.exe.
PanoUtil 13-Feb-2013 Written by David Azarewicz
For use only when a compatible Panorama is installed
Usage:
PanoUtil [switches] function
Switches:
-v : verbose
Functions:
-i : display adapter information
-q : query current MTRR settings
-p [d:] : Reset PM resolution to 800x600 on drive d:
-r [d:] : Reset custom resolution to default on drive d:
-d 0|1 [d:] : Enable/Disable custom resolution logic on drive d:
-c X Y [d:] : Set Custom resolution to X Y on drive d:
-e 0|Clk,H,V,Hbl,Vbl,Hof,Hw,Vof,Vw [d:] : Set custom EDID on drive d:
-s [d:] : Show custom resolution status on drive d:
-n 0|1 [d:] : Enable/Disable Use Native Resolution on drive d:
-m <base> <size> <flag> : Modify specific MTRR
base is in hex
size is in decimal and must have a k or m suffix
flag is 0 for disable, 1 for enable
example: PanoUtil -m d0000000 64m 1