Author Topic: Using a scanner with hplip?  (Read 38759 times)

Dave Yeo

  • Hero Member
  • *****
  • Posts: 4990
  • Karma: +111/-1
    • View Profile
Re: Using a scanner with hplip?
« Reply #45 on: April 29, 2019, 12:11:13 am »
Yes, the "musical note", hex value 0d, shows clearly, it exists at the end of all the hplip.conf lines.
Removed using kon and saved modified file.

That's actually a form feed (FF) rather then line ending character. Always a good idea to look with a hex editor.

Pete

  • Hero Member
  • *****
  • Posts: 1333
  • Karma: +9/-0
    • View Profile
Re: Using a scanner with hplip?
« Reply #46 on: April 29, 2019, 03:37:24 am »
Hi Dave

Yes, I stand corrected - although it is usually found towards the end of the line  :-)

Certainly worth remembering to look at data and .conf files ported from *nix using a hex editor if ported software is known to work but does not when unzipped/installed on a system. In this case it would have prevented a lot of "circular tail chasing"  ;-)


Regards

Pete




Paul Smedley

  • Hero Member
  • *****
  • Posts: 2249
  • Karma: +171/-0
    • View Profile
Re: Using a scanner with hplip?
« Reply #47 on: April 29, 2019, 11:33:56 am »
Hey Pete,

No need to send any logs, just glad it helped diagnose the problem!

Cheers,

Paul

Jochen Schäfer

  • Sr. Member
  • ****
  • Posts: 361
  • Karma: +29/-0
    • View Profile
Re: Using a scanner with hplip?
« Reply #48 on: April 29, 2019, 01:52:24 pm »
Yes, the "musical note", hex value 0d, shows clearly, it exists at the end of all the hplip.conf lines.
Removed using kon and saved modified file.

That's actually a form feed (FF) rather then line ending character. Always a good idea to look with a hex editor.
Actually, 0X0D = 13 is Carriage Return. Form Feed is 0X0C = 12.
« Last Edit: April 29, 2019, 09:24:14 pm by Jochen Schäfer »

Dave Yeo

  • Hero Member
  • *****
  • Posts: 4990
  • Karma: +111/-1
    • View Profile
Re: Using a scanner with hplip?
« Reply #49 on: April 29, 2019, 04:24:17 pm »
Yes, the "musical note", hex value 0d, shows clearly, it exists at the end of all the hplip.conf lines.
Removed using kon and saved modified file.

That's actually a form feed (FF) rather then line ending character. Always a good idea to look with a hex editor.
Actually, 0X0D = 13 ist Carriage Return. Form Feed is 0X0C = 12.

I must of been tired :) You're correct.