OS/2, eCS & ArcaOS - Technical > Hardware

eCS on an Acer Aspire One?

<< < (7/10) > >>

BigGoofyGuy:
'the eCS 2.1 code should work just fine! We nevver issued beta 2.2 specific codes.' - Here is the reply from eComStation tech person. I must be doing something wrong. I will try again.  8)

dbanet:

--- Quote from: Tom Lee Mullins on April 01, 2014, 03:43:10 am ---'the eCS 2.1 code should work just fine! We nevver issued beta 2.2 specific codes.' - Here is the reply from eComStation tech person. I must be doing something wrong. I will try again.  8)

--- End quote ---

No I believe it's not you ;)

Doug Bissett:

--- Quote ---I tried putting the registeration key on a a cd and a flash drive. It does not see it on either. The flash has the format of win32. Does this make a difference?
--- End quote ---

What do you mean by "format of Win32"?  I always use a flash drive, on a new system. I keep the eCS key on the hard disk for an old system. A Flash drive needs to be formatted as either FAT or FAT32, and if it is larger than 2 GB, it also requires a LVM volume to hold the FAT32 drive (FAT cannot be larger than 2 GB). The easy way to do that is to use DFSEE. There is a menu item to properly set up a flash drive. It is destructive, so save any data that may be on it, somewhere else, before you do it.

I have used a CD too, but I think it needs to be CDFS format, not UDF (especially not UDF that is not the OS/2 version).


--- Quote ---Even when I corrected errors, it still won't take it.
--- End quote ---

Trying to type a registration code is like trying to pick up 5 pounds of loose sand in your hands. You can do it 20 times, and you will make 20 (or more) errors.


--- Quote ---'disc 1 reports a corrupt partition table' - I keep getting this message when I try to make a section bootable.
--- End quote ---

This is pretty typical, when it already has another OS, on a modern computer. Other OSs use a Megabyte based partition table, while eCS only understands cylinder based partition tables. If you get REALLY lucky, they will match, but you are more likely to win a lottery. DFSEE seems to be able to figure it out, for disks smaller than about 512 GB. DFSEE is required for larger disks too, but they need to keep ALL of the eCS volumes below the 512 GB mark. The GOOD part is, that it is only LVM, when doing something that needs to change the partition table, that has the problem.

BigGoofyGuy:
I believe the flash drive I tried to use was either 4 gb or 8 gb. I will check again.

I will try again with the eCS 2.1 registration code.

I will check out the DFSee program to see if it makes a difference.
http://www.dfsee.com/


Thanks for the information. It is appreciated.  8)

BigGoofyGuy:
I was able to enter the eCS 2.1 code succesfully since I used a 'hunt and peck' instead of touch typing (not easy to do on a smaller keyboard).

When I try to create a volume (standard [bootable] volume) on the drive, it indicates 'operation no allowed', 'LVM ERROR (eight)'. (spellled 8 since it changes the number with ) into a smiley face).
 :(

One partition / drive shows the file system as (type 27)?

I have not tried the DFSee yet.  ::) I will see if I can create a bootable cd or flash drive to use it.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version