Hi,
Following a suggestion and Joop issue, I updated the build.
New 3.6.2.0 replacing old one put on my server today.
http://remydodin.levillage.org/doc/realisations/downloads/ClamAVGUI-3_6_2_0.wpiWarpin shows 3.6.2.1 as it should as well under clamavGUI help panel.
note: change Clamd (tcpip for plugin) to get right status if an old one already exist.
Here are latest changes since 3.6.1.5
3.6.2.1 - 2019/08/04
* Added Clamd recycle option under "File", usefull in case Clamd process goes into a very long scan or loop like (ex: system with 1Gb memory)
* TCPIP is now disabled by default under Clamd config file
* Added "Clamd (tcpip for plugin)" to enable/disable ClamD TCPIP into config file (TCPIP is required when ClamAV thunderbird plugin is installed). After change, config file is edited to check all is well done.
3.6.2.0 - 2019/07/30
* corrected virscan ico design and position according screensize
* code rewrite for rare not clamdscan pid detection (resulting into incorect scan stop + message)
* dll optimized (smaller bmp dll)
* QuickScan code optimized (removed duplicate scan and limited to filetype under some directories) and clamdscan confile updated
* added wait time until daemon is started when using clamdscan with quickscan without clamd loaded
* Corrected not always outofdate vir database detected by widget (cdwatch)
* desktop widget updated to correctly detect rxu.dll (not only under ..\OS2\dll)