OS/2, eCS & ArcaOS - Technical > Applications
ANPM on Warp 4.52 - Error and Loop on RPM/YUM install
Martin Iturbide:
Hi
I'm trying to install ANPM and with it RPM/YUM on a VM with Warp 4.52 (14.106).
I'm stuck on a loop trying to install RPM/YUM (Pic 1-Loop.png). The only strange thing that I see is that when it asks me to shut down (and I click OK), REXXAPI.DLL give me an error (2-Error.png).
Any ideas?
Regards
Dave Yeo:
Duplicate REXXAPI.DLL? Or similar with the older one taking precedence.
Dariusz Piatkowski:
Hi Martin,
It's been a while since I went through this, but I started with 4.52 as well, so here are some suggestions:
1) Take a look at the main AN RPM/YUM Wiki
https://www.arcanoae.com/wiki/anpm/
2) Take a look at the AN RPM/YUM 'Best Practices'
https://www.arcanoae.com/wiki/anpm/rpm-yum-best-practices/
3) Take a look at the AN 'Non-Updated Systems' Wiki
https://www.arcanoae.com/wiki/anpm/non-updated-systems/
4) Take a look at the AN 'How to install ANPM when there is an existing Python installation'
https://www.arcanoae.com/wiki/anpm/install-anpm-existing-python-installation/
This actually was something that I ran into, so we documented the work-around in that Wiki.
Here are the various REXXxxx DLLs I have on my system, all present in the \os2\dll :
Directory of G:\os2\dll
9-06-00 12:42p 266031 0 REXX.DLL
9-06-00 12:42p 40995 0 REXXAPI.DLL
9-06-00 12:42p 79348 0 REXXCRT.DLL
9-06-00 12:42p 8360 0 REXXINIT.DLL
9-06-00 12:42p 68119 0 REXXUTIL.DLL
REXXAPI.DLL is only present in that single location.
Martin Iturbide:
Hi
I just checked the REXX*.DLLs and I only have one and I'm on the same level.
By the way, I'm installing ANPM 1.0.4.
I also checked the POPUPLOG (Attached pic)
Regards
Andreas Schnellbacher:
Have you checked the prerequisites? Is kLIBC Pathrewriter installed?
Navigation
[0] Message Index
[#] Next page
Go to full version