Public Discussions > General Advertisements

ArcaOS DVD and bootable USB stick available

<< < (5/12) > >>

Rene Hvidsoe:

--- Quote from: Andreas Schnellbacher on June 08, 2020, 11:08:57 pm ---Hi Rene,


--- Quote from: Rene Hvidsoe on June 08, 2020, 07:22:47 pm ---I have in total 16 GB and aound 12 GB is set to ram disk.

Yes network and sound is working. Is a replacement for a 10 year old HP desktop that is showing its age.

PC is working very well.

--- End quote ---

thanks. I meant the RAM that's seen by OS/2, without the RAM disk. In ArcaOS, there exists the "mem" utility that shows the RAM available to the system. (I hope it's more than 2 GB.)

That mainboard has an old chipset, but is still available, what makes it so interesting.

--- End quote ---


Hi Andreas,

it shows 3.5 GB to ArcaOS.

This mb is working very well and has bought a another PC with simular HW.


Rene



Andreas Schnellbacher:

--- Quote from: Rene Hvidsoe on June 09, 2020, 07:08:32 am ---it shows 3.5 GB to ArcaOS.

--- End quote ---
Thanks, great.

Martin Iturbide:

--- Quote from: Dave Yeo on June 08, 2020, 03:59:38 am ---Yes, every version needs its USB stick updated for it. In the case of 5.0.5, you need the USB3 support on the stick. Kind of surprised the update seems to have worked for you.

--- End quote ---

Thanks, recreating my USB stick fixed my problem and now I can load the install procedure.

Regards

ivan:
As a matter of interest I now have all the USB ports working, the USB 3.1 and the USB 2 that hang off the USB 3 controller in the Ryzen processor as well as the USB 2 ports on the addin card - all 15 of them, though why I would need that many I don't know.

Pete:
Hi Doug

As there is no problem with attaching/ejecting the same USB3 drive to the same hardware multiple times when booted into Windows it is not likely to be a "flaky connector".

Using copy usbxhcd$ xhci_after_boot.rpt gives this information:-

   XHCI: XhciGenericDone: pRBD=fb816114 DevAdr=1 EpId=0 error=12

After an attach and eject using copy usbxhcd$ xhci_after_boot.rpt gives this information:-
 
   XHCI: XhciGenericDone: pRBD=fb816114 DevAdr=1 EpId=0 error=12
   XHCI: XhciGenericDone: pRBD=fb816114 DevAdr=1 EpId=4 error=16
   XHCI: XhciGenericDone: pRBD=fb816114 DevAdr=1 EpId=4 error=16


Not sure how important the error codes are but after the 1st eject the USB3 drive cannot be attached until after a reboot usually - very occasionally it does attach a 2nd time but never a third time.


Regards

Pete



 

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version