OS/2, eCS & ArcaOS - Technical > Hardware

ThinkPad X60 tablet pen & multi-touch support?

(1/3) > >>

Alex Taylor:
I recently picked up an X60t (pen+multitouch model) because I need a highly portable system for carrying around campus.

I've installed eCS 2.2 beta - so far so good, for the most part - all the usual basic devices work (although I had to change the video to Panorama as I got constant hangs with SNAP).

Now I'm looking at getting the touchscreen working. I downloaded Wim Brul's PENTOOLS02.ZIP and have been going through the instructions. However, I'm kind of stuck. I managed to compile and run ACPITREE.EXE for current ACPI. However, the output doesn't show any IRQ value, so I'm not sure what to specify when loading PSCOM.SYS.

         +*DTR_ T:[Device] HID:[WACF008] STA:[0xf]
 Current state:
      > IO:[1 0x200 - 0x200 Al:1 Len:8]
      >Trigger by Edge, Polarity High
      > ENDTAG

I tried the (1,200,4,I) value suggested for the X61.  However, when I run COMRAW.CMD with that set, and try a few stylus actions, I just get a 0-byte 19200.RAW file.

Any ideas?

Eugene Gorbunoff:
1) Better change laptop to Thinkpad X61 Tablet.

2) I don't know, is it necessary activate COM-port in BIOS setup? Does it influence on Wacom controller or not.

ivan:
Eugene, that is no help to Alex at all.

Alex Taylor:
The tablet works fine in Windows so presumably the hardware is enabled.

Mo:
Hi Alex,

Happy new year!

On my old x61t the com port used irq 5 instead of 4. I needed to change (1,200,4,I) to (1,200,5,I).



Navigation

[0] Message Index

[#] Next page

Go to full version