OS/2, eCS & ArcaOS - Technical > Setup & Installation

ArccaOS 5.0.6 does not see hard disk; FAT32 problems

(1/1)

Martin Vieregg:
(1) I have got two HDs installed, a SSD with the operating systems and a bigger HDD for backups, videos, music and so on. I have got both 5.0.2 and 5.0.6 installed. 5.0.6 does not see the HDD, 5.0.2 and Windows sees it. Any ideas?

(2) I thaught that the ArcaOS FAT32 driver is the more stable one, compared to the Netlabs version. But now I tried to copy 500 MB of data to the FAT32 drive (internal SSD) with the original ArcaOS FAT32 driver. Copy runs without problems. But after restarting, both Windows and ArcaOS does not see the new files anymore. chkdsk /D on Windows has no effect. (This had always an effect with Netlabs driver). Any ideas?

Gregg Young:

--- Quote from: Martin Vieregg on November 06, 2021, 04:58:52 pm ---(2) I thaught that the ArcaOS FAT32 driver is the more stable one, compared to the Netlabs version. But now I tried to copy 500 MB of data to the FAT32 drive (internal SSD) with the original ArcaOS FAT32 driver. Copy runs without problems. But after restarting, both Windows and ArcaOS does not see the new files anymore. chkdsk /D on Windows has no effect. (This had always an effect with Netlabs driver). Any ideas?

--- End quote ---

Are you running FAT32 without the cache? If so turning it on should fix the problem. This has been fixed and should be available from AN in the near future. If this isn't the problem put in a ticket with AN.

Pete:
Hi Martin


--- Quote from: Martin Vieregg on November 06, 2021, 04:58:52 pm ---(1) I have got two HDs installed, a SSD with the operating systems and a bigger HDD for backups, videos, music and so on. I have got both 5.0.2 and 5.0.6 installed. 5.0.6 does not see the HDD, 5.0.2 and Windows sees it. Any ideas?

--- End quote ---

When booted from 5.0.6 what does LVM show about the HDD?

May be worth checking the 5.0.6 config.sys against the (working) 5.0.2 config.sys to see if 5.0.6 is loading the correct driver(s) and any necessary parameters are present.


Regards

Pete

Navigation

[0] Message Index

Go to full version