OS/2, eCS & ArcaOS - Technical > Multimedia
[SOLVED] OS/2 Warp 4.52 VM, changing audio to Uniaud
Martin Iturbide:
--- Quote from: David McKenna on September 23, 2022, 04:04:16 pm --- Hi Martin,
Look in the C:\MMOS2\INSTALL folder. There should be a folder with the SoundBlaster install files in it....
Regards,
--- End quote ---
Thanks for the feedback, but I don't find nothing (control file or SB files) on the install folder.
I guess I need to find some SB control.scr file somewhere to do the uninstall with MMOS2.
Regards
mauro:
--- Quote from: Dave Yeo on September 24, 2022, 05:36:50 pm ---Hi mauro, you need "SET KAI_AUTOMODE=DART" in your environment (config.sys is simplest) to force the Mozilla apps to use DART rather then UNIAUD for sound. UNIAUD is broken as you found.
Edit: Actually the set command should work for any program using libkai for audio.
--- End quote ---
Hi Dave, in my config.sys I had the two active call sametime
SET KAI_AUTOMODE=DART
SET KAI_AUTOMODE=UNIAUD
so I tried to REM one first, then just one/other, then both.
Rebooted system on each change.
Nothing happened, system sound ok but no audio from video clip.
I believe there is some issue with Virtualbox audio filters.
Thank you
PS in the other UNIAUD thread I read Paul is continuously updating the drivers, I keep using a version downloaded on beginning september
David McKenna:
Hi Martin,
Strange there is no folder with the soundblaster drivers... I guess you will have to find the original driver package and use that (maybe at Hobbes - or on the OS/2 Warp disk you used?). Open a command prompt, navigate to the folder with the soundblaster install files, then run Minstall there. Use '0' (zero) for the number of cards in order to remove it.
Regards,
Martin Iturbide:
Hi
I installed the Warp 4.52 Sound Blaster driver when I created the image with the "Warp 4 Setup and Installation". I search on the CD if there was the Sound Blaster driver alone with the .scr file and I was not able to find it. Any other tip?
Regards
David McKenna:
Hi Martin,
Without the install files, you are pretty much stuck with trying to edit MMPM2.INI by hand, unfortunately.
Regards,
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version