OS/2, eCS & ArcaOS - Technical > Setup & Installation

New install - Intel NUC5

<< < (2/3) > >>

Martin Iturbide:
Hi Rick

That's good.

Please post back if everything works and your PCI report (I have some instructions here).

I had created a wiki page for it here: "Intel NUC Kit D54250WYKH".

Reading the specs the only strange thing it has is the "Consumer Infrared Rx Sensor", but the rest seems that it should not give you problems, please report back.

Regards

Dave Yeo:

--- Quote from: Rick Smith on December 28, 2022, 10:10:03 pm ---I have two partitions "cleared" via gparted ie not formatted.. Arca still does not see them, the only thing that pops up in disk manager is a 16mb fat16 device not sure what that is, but its been there each time.  Of course the usb device is there as well.  Were you saying there is a way to boot to disk manager on the arca install usb?


**UPDATE**

I got it to work, I had one option left to try, so I booted back to gparted created msdos partition table, left drive unpartitioned and unformatted, arca is now installing as we speak...

Rick

--- End quote ---

Good to hear. As for the maintenance boot, when you boot the install stick, after the installer starts, at the lower right is a maintenance button, forget the exact wording. It'll bring up a minimal GUI with various menu items.

Rick Smith:

--- Quote from: Martin Iturbide on December 28, 2022, 11:22:41 pm ---Hi Rick

That's good.

Please post back if everything works and your PCI report (I have some instructions here).

I had created a wiki page for it here: "Intel NUC Kit D54250WYKH".

Reading the specs the only strange thing it has is the "Consumer Infrared Rx Sensor", but the rest seems that it should not give you problems, please report back.

--- End quote ---

Its installed, infact I am writing this on that machine.  The reboot though went weird, when I selected boot from hard disk in would go into a loop and complain about boot disk being a floppy?  So I took usb out and it booted from hard drive I quickly reinserted the usb drive tho so it could keep installing after the reboot.. All in all went fine.  I am having that dos prompt problem where it wont work if you open a dos window, I may try the documented fixes and see if I have any luck.

Here is the file you requested.

Rick

Martin Iturbide:
Thanks Rick. I had updated the wiki.

Does everything works fine Audio, Network, All USB ports?

FYI: I guess you already known, but I got good results with " viop-1.0.wpi" for the DOS sessions.

Regards

Rick Smith:

--- Quote from: Martin Iturbide on December 29, 2022, 01:07:50 pm ---Thanks Rick. I had updated the wiki.

Does everything works fine Audio, Network, All USB ports?

FYI: I guess you already known, but I got good results with " viop-1.0.wpi" for the DOS sessions.
Regards

--- End quote ---

Great!  With the viop-1.0.wpi was there something to add to autoexec.bat as well?  I thought I remember something along those lines but could be wrong..  Everything as far as I can tell is working just fine.. Ive tested all the ports, and I can produce audio.


Rick

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version