OS/2, eCS & ArcaOS - Technical > Setup & Installation

ArcaOS 5.1

<< < (8/8)

Remy:
Hi !

Because 5.1 migration failes, I decided to give a try to 5.0.8 migration i never did.
The 5.0.8 migration ended successfully !
Compared to 5.1, the migration seems having same process until end of phase 2 but then, 5.1 migration has additional TCPIP and TCPIP Applications steps ending with the error message.

Those having done 5.1 migration, do you remember having gone through tcpip processes after phase 2 (following first reboot) ?

Regards
Rémy

Remy:
Problem found and after correction, migration to 5.1 was ok.

Migration went into error due it doesn't recognize parameter metric on the ifconfig line while it well handle the ifconfig entry command
(I added a line in the past to change some specification on my interface 0 using the ifconfig command into the setup.cmd - something which should work)

ivan:
Hi Remy,

After all your fun and games is there any advantage going to 5.1?  At the moment I am quite happy with 5.0.7 that is working without problems on my 30 inch 2560x1600 monitor.

Remy:

--- Quote from: ivan on August 27, 2024, 11:36:54 pm ---Hi Remy,

After all your fun and games is there any advantage going to 5.1?  At the moment I am quite happy with 5.0.7 that is working without problems on my 30 inch 2560x1600 monitor.

--- End quote ---

Well, it seems to be more stable (may be better responsiveness but this is a subjective value)
Once the migration issue found, migration was fast.
currently, I'm satisfied

note: if arcamap was used under 5.0.x, this one is no more available under ArcaOS 5.1 (replaced by samba). I took my saved copy with its config file used in a local network only and it works.

Navigation

[0] Message Index

[*] Previous page