OS/2, eCS & ArcaOS - Technical > Networking

arcmapper

<< < (2/4) > >>

Rick Smith:

--- Quote from: Alex Taylor on November 13, 2023, 01:56:15 am ---BTW, the "authentication concepts" section of the ArcaMapper guide, and the Credential Manager section, provide some (hopefully useful) information.

--- End quote ---

When I look at the active credentials after I manually restore the connection, my credentials say valid until shutdown?  Not sure if that is what it is suppose to look like, none the less it still errors on reboot that it could not connect to the share until I open arcmapper and restore connection?

Regards,

Rick

Rick Smith:
Greetings,

I have tried every which way I can, it fails to connect on reboot until I open arcamapper and click restore connections, then it connects just fine.

Regards.

Rick

Alex Taylor:
Just out of curiousity, are you using DHCP?

It's possible that restoring connections might fail if you haven't acquired an IP address yet.

Rick Smith:

--- Quote from: Alex Taylor on November 15, 2023, 03:55:52 am ---Just out of curiousity, are you using DHCP?

It's possible that restoring connections might fail if you haven't acquired an IP address yet.

--- End quote ---

I could assign that machine a static ip and retest it.

Rick

Rick Smith:
Greetings,

Setting static IP did not change anything.  Still errors at boot and easily connects by clicking restore connection.  How would I go about reinstalling just that package?

Rick

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version