OS/2, eCS & ArcaOS - Technical > Communication

COM Port Setup

(1/4) > >>

christech:
I am trying to setup a COM port under ArcaOS. Do I need to add any statements in Config.sys? I tried mode com1 through com8 and it's not recognized. I don't see any COM ports in the hardware manager either. I'm not using a USB->Serial but an actual COM port on the motherboard.

Doug Bissett:

--- Quote from: christech on November 28, 2023, 05:55:13 pm ---I am trying to setup a COM port under ArcaOS. Do I need to add any statements in Config.sys? I tried mode com1 through com8 and it's not recognized. I don't see any COM ports in the hardware manager either. I'm not using a USB->Serial but an actual COM port on the motherboard.
--- End quote ---

The AcaOS installer often misses the presence of a COM port. Look in CONFIG.SYS, for:

--- Code: ---DEVICE=C:\OS2\BOOT\PSCOM.SYS
--- End code ---
(C: is your boot drive). If it is not there, add it. If it is there (a remote possibility is that it will be COM.SYS), it should work.

Note, that software modems won't always work.

christech:
Yeah I looked and it's not in my Config.sys. I will add it. I remember on my USB->Serial I needed to add a Device statement.

Martin Iturbide:
Hello christech

Even that I have two USB to Serial adapters, I no longer have an Serial device to try it out  :'(

I wrote a little thing on the wiki under "Testing the Device" : https://www.os2world.com/wiki/index.php/Prolifc_PL2303_USB_2.0_to_COM

If you succeed your testing, I will apreciate if you can post back the HardwareID of your USB to Serial device, and with which serial device did you make it work.

Regards

christech:
I sure will it's a generic USB one.. I got it from Amazon. It was doing some weird stuff though. It mostly worked, I have a thread here somewhere. I have a ton of serial devices that I want to test out, like some CP/M SBC's and Routers/Switches etc.

Navigation

[0] Message Index

[#] Next page

Go to full version