1
General Discussion / Re: PMfax
« Last post by Wayne A. Smith on Today at 10:06:43 pm »OK, Dave.
The output is:
[C:\]mode com1
baud = 9600 parity = NONE
databits = 8 stopbits = 1
TO = OFF XON = OFF
IDSR = OFF ODSR = OFF
OCTS = OFF DTR = ON
RTS = ON BUFFER = N/A
[C:\]mode com2
baud = 9600 parity = NONE
databits = 8 stopbits = 1
TO = OFF XON = OFF
IDSR = OFF ODSR = OFF
OCTS = OFF DTR = ON
RTS = ON BUFFER = N/A
[C:\]mode com3
SYS0021: The drive is not ready.
This is consistent w/ the <COM.SYS> parameters. Strange that PMFax reports COM3 UNLESS it is accessing the <USBCOM.SYS> setting rather than the <COM.SYS> setting.
The output is:
[C:\]mode com1
baud = 9600 parity = NONE
databits = 8 stopbits = 1
TO = OFF XON = OFF
IDSR = OFF ODSR = OFF
OCTS = OFF DTR = ON
RTS = ON BUFFER = N/A
[C:\]mode com2
baud = 9600 parity = NONE
databits = 8 stopbits = 1
TO = OFF XON = OFF
IDSR = OFF ODSR = OFF
OCTS = OFF DTR = ON
RTS = ON BUFFER = N/A
[C:\]mode com3
SYS0021: The drive is not ready.
This is consistent w/ the <COM.SYS> parameters. Strange that PMFax reports COM3 UNLESS it is accessing the <USBCOM.SYS> setting rather than the <COM.SYS> setting.