1
Hardware / Re: The operating system does not boot after replacing the motherboard
« on: June 08, 2025, 07:49:21 pm »Have you a business case for using OS/2? You might want to upgrade to AOS, an OEM version of OS/2. https://www.arcanoae.com where you will get support as well as the latest drivers etc.
Hi Again
My machine does not have a floppy drive but it does have a CD
I noticed that the operating system 14.086_W4 does not have the SATA driver for my new motherboard
I tried everything but could not add the Danis506 1-8-15 driver to the operating system 14.086_W4 and I searched the internet but could not find any guidance on this matter and the guidance within the driver file itself was very vague and I did not understand anything!
I installed the ArcaOS 5.0 operating system on hard disk 2 and connected the hard disk 1 with the OS/2 Warp 14.086_W4 operating system installed to it and was able to access the files on the hard disk.
I have two questions:
1 - This hard disk is for a printer that is connected to this system via the COM port. I do not have the printer software installation file that was installed on the ArcaOS 5.0 operating system
Do you think I can copy the software from hard disk 1 with OS/2 Warp 14.086_W4 to hard disk 2nd ArcaOS 5.0 And use it?
If you have any suggestions, please guide me
2 - How can I copy the Danis506 1-8-15 driver from the ArcaOS operating system that I installed on the 2nd hard disk into the OS/2 Warp 14.086_W4 operating system so that the SATA driver of my new motherboard is added to the operating system and the booting problem is solved
The operating system ArcaOS 5.0 has the Danis506 1-8-15 driver and the operating system is easy to install and work with.
I am eagerly awaiting your kindness and cooperation
Question is this a datacard 9000 system ?:
Roderick