Craig Hart's PCI+AGP bus sniffer, Version 1.04vkA, freeware made in 1996-2005. Loaded Vendor Data : "This is version 2018.01.14 of pci.ids using ids2devs version 1.03" PCI BIOS Version 2.10 found! Number of PCI Busses : 8 PCI Characteristics : Config Mechanism 1 Searching for PCI Devices using the OEMHLP$ driver Bus 0 (PCI), Device Number 0, Device Function 0 Vendor 8086h Intel Corporation Device 7190h 440BX/ZX/DX - 82443BX/ZX/DX Host bridge Command 0106h (Memory Access, BusMaster, System Errors) Status 2210h (Has Capabilities List, Received Master Abort, Medium Timing) Revision 03h, Header Type 00h, Bus Latency Timer 40h Self test 00h (Self test not supported) PCI Class Bridge, type PCI to HOST Address 0 is a Memory Address (0-4GiB, Prefetchable) : F8000000h..FBFFFFFFh New Capabilities List Present: AGP Capability, Version 1.0 (AGP 1x and/or 2x support) AGP Speed(s) Supported : 1x 2x FW Transfers Supported : No >4GiB Address Space Supported : No Sideband Addressing Supported : Yes Maximum Command Queue Length : 32 bytes AGP Speed Selected : 2x FW Transfers Enabled : No >4GiB Address Space Enabled : No AGP Enabled : Yes Sideband Addressing Enabled : Yes Current Command Queue Length : 1 byte Bus 0 (PCI), Device Number 1, Device Function 0 Vendor 8086h Intel Corporation Device 7191h 440BX/ZX/DX - 82443BX/ZX/DX AGP bridge Command 001Fh (I/O Access, Memory Access, BusMaster, Special Cycles, MemWrite+Invalidate) Status 0220h (Supports 66MHz, Medium Timing) Revision 03h, Header Type 01h, Bus Latency Timer 80h Self test 00h (Self test not supported) PCI Class Bridge, type PCI to PCI PCI Bridge Information: Primary Bus Number 0, Secondary Bus Number 1, Subordinate Bus number 1 Secondary Bus Command 008Ch (ISA mapping, VGA mapping, back-to-back transactions) Secondary Bus Status 22A0h (Supports 66MHz, Supports Back-To-Back Trans., Received Master Abort, Medium Timing) Secondary Bus Latency 40h I/O Port Range Passed to Secondary Bus : 2000h..2FFFh (16-bit) Memory Range Passed to Secondary Bus : F4100000h..F5FFFFFFh Prefetchable Memory Range Passed to Secondary Bus : None Bus 0 (PCI), Device Number 7, Device Function 0 Vendor 8086h Intel Corporation Device 7110h 82371AB/EB/MB PIIX4 ISA Command 000Fh (I/O Access, Memory Access, BusMaster, Special Cycles) Status 0280h (Supports Back-To-Back Trans., Medium Timing) Revision 02h, Header Type 80h, Bus Latency Timer 00h Self test 00h (Self test not supported) PCI Class Bridge, type PCI to Other Bus 0 (PCI), Device Number 7, Device Function 1 Vendor 8086h Intel Corporation Device 7111h 82371AB/EB/MB PIIX4 IDE Command 0005h (I/O Access, BusMaster) Status 0280h (Supports Back-To-Back Trans., Medium Timing) Revision 01h, Header Type 00h, Bus Latency Timer 40h Self test 00h (Self test not supported) PCI Class Storage, type IDE (ATA) PCI EIDE Controller Features : BusMaster EIDE is supported Primary Channel is at I/O Port 01F0h and IRQ 14 Secondary Channel is at I/O Port 0170h and IRQ 15 Address 0 is not present or not configured! Address 1 is not present or not configured! Address 2 is not present or not configured! Address 3 is not present or not configured! Address 4 is an I/O Port : 1800h..1807h Bus 0 (PCI), Device Number 7, Device Function 2 Vendor 8086h Intel Corporation Device 7112h 82371AB/EB/MB PIIX4 USB Command 0005h (I/O Access, BusMaster) Status 0280h (Supports Back-To-Back Trans., Medium Timing) Revision 01h, Header Type 00h, Bus Latency Timer 40h Self test 00h (Self test not supported) PCI Class Serial, type USB (UHCI) Address 0 is not present or not configured! Address 1 is not present or not configured! Address 2 is not present or not configured! Address 3 is not present or not configured! Address 4 is an I/O Port : 1820h..1833h System IRQ 11, INT# D Bus 0 (PCI), Device Number 7, Device Function 3 Vendor 8086h Intel Corporation Device 7113h 82371AB/EB/MB PIIX4 ACPI Command 0003h (I/O Access, Memory Access) Status 0280h (Supports Back-To-Back Trans., Medium Timing) Revision 03h, Header Type 00h, Bus Latency Timer 00h Self test 00h (Self test not supported) PCI Class Bridge, type PCI to Other Bus 0 (PCI), Device Number 8, Device Function 0 Vendor 1180h Ricoh Co Ltd Device 0476h RL5c476 II Command 0007h (I/O Access, Memory Access, BusMaster) Status 0210h (Has Capabilities List, Medium Timing) Revision 80h, Header Type 82h, Bus Latency Timer 40h Self test 00h (Self test not supported) PCI Class Bridge, type PCI to Cardbus Subsystem ID 01851014h Unknown Subsystem Vendor 1014h IBM System IRQ 11, INT# A CardBus Bridge Information: PCI Bus Number 0, CardBus Bus Number 2, Subordinate Bus number 4 CardBus Latency B0h Secondary Bus Command 0780h (ints routed by ExCA, write post enable) Secondary Bus Status 0200h (Medium Timing) Socket/ExCa Base Memory Address : 50000000h..50000FFFh Memory Range 0 : None Memory Range 1 : None I/O Port Range 0 : None I/O Port Range 1 : None New Capabilities List Present: Power Management Capability, Version 1.0 Supports low power State D1 Supports low power State D2 Supports PME# signalling from mode(s) D0, D1, D2, D3hot, D3cold PME# signalling is currently disabled 3.3v AUX Current required : 0 mA (Self powered) Current Power State : D0 (Device operational, no power saving) 360 mW D0 power consume 360 mW D0 power dissipate 320 mW D1 power consume 320 mW D1 power dissipate 10 mW D2 power consume 10 mW D2 power dissipate 10 mW D3 power consume 10 mW D3 power dissipate 0 mW common logic power consume Bus 0 (PCI), Device Number 8, Device Function 1 Vendor 1180h Ricoh Co Ltd Device 0476h RL5c476 II Command 0007h (I/O Access, Memory Access, BusMaster) Status 0210h (Has Capabilities List, Medium Timing) Revision 80h, Header Type 82h, Bus Latency Timer 40h Self test 00h (Self test not supported) PCI Class Bridge, type PCI to Cardbus Subsystem ID 01851014h Unknown Subsystem Vendor 1014h IBM System IRQ 11, INT# B CardBus Bridge Information: PCI Bus Number 0, CardBus Bus Number 5, Subordinate Bus number 7 CardBus Latency B0h Secondary Bus Command 0780h (ints routed by ExCA, write post enable) Secondary Bus Status 0200h (Medium Timing) Socket/ExCa Base Memory Address : 50100000h..50100FFFh Memory Range 0 : None Memory Range 1 : None I/O Port Range 0 : None I/O Port Range 1 : None New Capabilities List Present: Power Management Capability, Version 1.0 Supports low power State D1 Supports low power State D2 Supports PME# signalling from mode(s) D0, D1, D2, D3hot, D3cold PME# signalling is currently disabled 3.3v AUX Current required : 0 mA (Self powered) Current Power State : D0 (Device operational, no power saving) 360 mW D0 power consume 360 mW D0 power dissipate 320 mW D1 power consume 320 mW D1 power dissipate 10 mW D2 power consume 10 mW D2 power dissipate 10 mW D3 power consume 10 mW D3 power dissipate 0 mW common logic power consume Bus 0 (PCI), Device Number 10, Device Function 0 Vendor 8086h Intel Corporation Device 4220h PRO/Wireless 2200BG [Calexico2] Network Connection Command 0016h (Memory Access, BusMaster, MemWrite+Invalidate) Status 0290h (Has Capabilities List, Supports Back-To-Back Trans., Medium Timing) Revision 05h, Header Type 00h, Bus Latency Timer 40h Minimum Bus Grant 03h, Maximum Bus Latency 18h Self test 00h (Self test not supported) Cache line size 32 Bytes (8 DWords) PCI Class Network, type Other Subsystem ID 12F6103Ch Unknown Subsystem Vendor 103Ch Hewlett-Packard Company Address 0 is a Memory Address (0-4GiB) : F4010000h..F4010FFFh System IRQ 11, INT# A New Capabilities List Present: Power Management Capability, Version 1.1 Does not support low power State D1 or D2 Supports PME# signalling from mode(s) D0, D3hot, D3cold PME# signalling is currently disabled 3.3v AUX Current required : 0 mA (Self powered) Current Power State : D0 (Device operational, no power saving) 1900 mW D0 power consume 1900 mW D0 power dissipate 1900 mW D1 power consume 1900 mW D1 power dissipate 1900 mW D2 power consume 1900 mW D2 power dissipate 100 mW D3 power consume 100 mW D3 power dissipate 0 mW common logic power consume Bus 0 (PCI), Device Number 11, Device Function 0 Vendor 1013h Cirrus Logic Device 6005h Crystal CS4281 PCI Audio Command 0006h (Memory Access, BusMaster) Status 0210h (Has Capabilities List, Medium Timing) Revision 01h, Header Type 00h, Bus Latency Timer 40h Minimum Bus Grant 04h, Maximum Bus Latency 18h Self test 00h (Self test not supported) PCI Class Multimedia, type Audio Subsystem ID 01831014h Unknown Subsystem Vendor 1014h IBM Address 0 is a Memory Address (0-4GiB) : F4011000h..F4011FFFh Address 1 is a Memory Address (0-4GiB) : F4000000h..F400FFFFh System IRQ 11, INT# A New Capabilities List Present: Power Management Capability, Version 1.1 Supports low power State D1 Supports low power State D2 Supports PME# signalling from mode(s) D0, D1, D2, D3hot PME# signalling is currently disabled 3.3v AUX Current required : 0 mA (Self powered) Current Power State : D0 (Device operational, no power saving) Bus 1 (AGP), Device Number 0, Device Function 0 Vendor 1002h Advanced Micro Devices, Inc. [AMD/ATI] Device 4C4Dh Rage Mobility AGP 2x Series Command 0087h (I/O Access, Memory Access, BusMaster, Wait Cycles) Status 0290h (Has Capabilities List, Supports Back-To-Back Trans., Medium Timing) Revision 64h, Header Type 00h, Bus Latency Timer 42h Minimum Bus Grant 08h, Maximum Bus Latency 00h Self test 00h (Self test not supported) Cache line size 32 Bytes (8 DWords) PCI Class Display, type VGA Subsystem ID 01821014h Unknown Subsystem Vendor 1014h IBM Address 0 is a Memory Address (0-4GiB) : F5000000h Address 1 is an I/O Port : 2000h..20FFh Address 2 is a Memory Address (0-4GiB) : F4100000h..F4100FFFh System IRQ 11, INT# A Expansion ROM of 128 KiB decoded by this card, currently disabled New Capabilities List Present: AGP Capability, Version 1.0 (AGP 1x and/or 2x support) AGP Speed(s) Supported : 1x 2x FW Transfers Supported : No >4GiB Address Space Supported : No Sideband Addressing Supported : Yes Maximum Command Queue Length : 256 bytes AGP Speed Selected : 2x FW Transfers Enabled : No >4GiB Address Space Enabled : No AGP Enabled : Yes Sideband Addressing Enabled : Yes Current Command Queue Length : 1 byte Power Management Capability, Version 1.1 Supports low power State D1 Supports low power State D2 Does not support PME# signalling Current Power State : D0 (Device operational, no power saving) ROM PCI IRQ routing table Tests.... ROM IRQ routing table found at F000h:DEE0h Table Version 1.0 - OK Table size 208 bytes - OK Table Checksum 1Bh - OK PCI Interrupt Router: 82371AB/EB/MB PIIX4 ISA IRQ's dedicated to PCI : None The ROM PCI IRQ routing table appears to be OK. IRQ Summary: IRQs 11,14,15 are used by PCI devices Shared IRQs: IRQ 11 is shared by 6 PCI Devices