=============================================================================== MPTable, version 2.0.12 looking for EBDA pointer @ 0x040e, found, searching EBDA @ 0x0009f800 searching CMOS 'top of mem' @ 0x0009f400 (637K) searching default 'top of mem' @ 0x0009fc00 (639K) searching BIOS @ 0x000f0000 MP FPS found in BIOS @ physical addr: 0x000f8500 ------------------------------------------------------------------------------- MP Floating Pointer Structure: location: BIOS physical address: 0x000f8500 signature: '_MP_' length: 16 bytes version: 1.4 checksum: 0x2a mode: Virtual Wire ------------------------------------------------------------------------------- MP Config Table Header: physical address: 0x0009fd70 signature: 'PCMP' base table length: 296 version: 1.4 checksum: 0x48 OEM ID: ' ' Product ID: ' ' OEM table pointer: 0x00000000 OEM table size: 0 entry count: 30 local APIC address: 0xfee00000 extended table length: 0 extended table checksum: 0 ------------------------------------------------------------------------------- MP Config Base Table Entries: -- Processors: APIC ID Version State Family Model Step Flags 0 0x10 BSP, usable 15 4 10 0x78bfbff -- Bus: Bus ID Type 0 PCI 1 PCI 2 ISA -- I/O APICs: APIC ID Version State Address 1 0x03 usable 0xfec00000 -- I/O Ints: Type Polarity Trigger Bus ID IRQ APIC ID INT# ExtINT active-hi edge 2 0 1 0 INT active-hi edge 2 1 1 1 INT active-hi edge 2 0 1 2 INT active-hi edge 2 3 1 3 INT active-hi edge 2 4 1 4 INT active-hi edge 2 5 1 5 INT active-hi edge 2 6 1 6 INT active-hi edge 2 7 1 7 INT active-hi edge 2 8 1 8 INT active-lo level 0 12:A 1 16 INT active-lo level 0 16:C 1 18 INT active-lo level 0 16:B 1 17 INT active-hi edge 2 12 1 12 INT active-hi edge 2 13 1 13 INT active-hi edge 2 14 1 14 INT active-hi edge 2 15 1 15 INT active-lo level 0 16:A 1 16 INT active-hi conforms 0 16:D 255 232 INT active-lo level 0 17:C 1 18 INT active-lo level 0 17:C 1 18 INT active-lo level 0 18:A 1 16 INT active-hi conforms 0 19:A 255 232 INT active-lo level 1 0:A 1 16 -- Local Ints: Type Polarity Trigger Bus ID IRQ APIC ID INT# ExtINT active-hi edge 2 0 255 0 NMI active-hi edge 0 0:A 255 1 ------------------------------------------------------------------------------- # SMP kernel config file options: # Required: options SMP # Symmetric MultiProcessor Kernel options APIC_IO # Symmetric (APIC) I/O # Useful: #options SMP_AUTOSTART # start the additional CPUs during boot # Optional (built-in defaults will work in most cases): #options NCPU=1 # number of CPUs #options NBUS=3 # number of busses #options NAPIC=1 # number of IO APICs #options NINTR=24 # number of INTs # Rogue hardware: # # Tyan Tomcat II: #options SMP_TIMER_NC # # # SuperMicro P6DNE: #options SMP_TIMER_NC # ===============================================================================