Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - OS4User

Pages: [1] 2 3 ... 24
1
Multimedia / Re: Updated Uniaud32 build
« on: September 18, 2022, 07:36:37 am »

2
I remember very well the battle between OS/2 Warp and Win95 (and subsequent).
Win95 was very bad in terms of technology, but it wins for several reasons:

OS/2 did not offer:
- A good office set (Word, Exell, Scanning Soft), (IBM proposal was very poor)
- Good games (new ones released only for Win)
- Proper hardware support (drivers for sound and video cards)

This story showed us that it is not enough to make an excellent OS. For its success, you still need to release a huge number of applications at least to begin with.

3
Applications / Re: Implemented DUMPFS.IFS as a 32-bit IFS
« on: July 29, 2022, 03:46:45 am »
DumpFS32 3.0     works ok  here

4
Off Topic discussions / Re: Lying low for a few days
« on: June 19, 2022, 01:48:10 pm »
regrets

5
Applications / Re: Test build of dooble with qt5
« on: June 18, 2022, 11:34:03 am »
For me though,  it doesn't seem to be rendering a page - does it work for anyone else?

it works ok for me  -  at least showed  https://www.speedtest.net/

6
Hardware / Re: Lenovo Thinkcentre M73p
« on: June 16, 2022, 08:27:23 am »
This arrived yesterday, and I installed ArcaOS 5.0.7 successfully on it today :) NIC and Sound were detected by the installer.

How much memory does OS/2 see?

7
Setup & Installation / Re: OS/4 Problem SVN6139
« on: June 10, 2022, 08:18:09 am »
Thanks Lars & OS4user

You are always welcome

,it looks like there might be problems with using multiple processors

it should not, it works ok SMP too


8
Setup & Installation / Re: OS/4 Problem SVN6139
« on: June 09, 2022, 07:55:27 am »
H os4user, Thsnks for the help, I could'nt get irc://efnet/os2russiann to work.

To get to irc you need an irc client for example http://chatzilla.hacksrus.com/xpi/chatzilla-0.9.93.xpi

I tried remming out PMDDK.sys and it boots until 

The system cannot operate without PMDD(K).sys

Pls show your config.os4

9
Setup & Installation / Re: OS/4 Problem SVN6139
« on: June 08, 2022, 07:23:43 pm »
The included  "HowTo  still says it needs a patch like SVN6139.!

klipp

pls come to irc://efnet/os2russian  may be we can solve the case

10
Setup & Installation / Re: OS/4 Problem SVN6139
« on: June 08, 2022, 08:16:38 am »
Specifying VALIMIT=3072 seems to fix the trap that I was experiencing.

It is difficult to imagine the connection of trap with VAL. If you can show some of them it may help.

... 8 cores. Looks like there is something wrong with the thread scheduling (it blocks for extended periods).

Interesting, I run with 4 cores - newer seen.  Any details?

11
Setup & Installation / Re: OS/4 Problem SVN6139
« on: June 08, 2022, 08:01:41 am »
Thaks for any help you ca offer.    klipp

Hi. Everything you need to install OS/4 is in the distributive. You just have to follow the NowTo step by step.

12
Hardware / Re: Lenovo Thinkcentre M73p
« on: June 06, 2022, 10:59:23 am »
Hey All,

It would be nice to have native hardware running OS/2. Any thoughts on this? https://www.ozbargain.com.au/node/704712

Seems not bad choice.

Main points  are:
 - how much RAM is mapped below 4Gb boarder
 - is ethernet driver available 
 - does Uniaud support the chip
The rest looks good    -  especially comport
And pay attention to video output  connectors


13
Others need to distribute the patches, and let the user do the work to apply them. Patches are often done automatically, by installers, when something is installed.

Seems this idea is not new. Once, I have seen ftp with patches to convert OS/2 kernel to OS/4 level. Somehow I did not pay attention to this and did not add it to my bookmarks. I tried to find it again, but unfortunately without success.

14
...actually, I have to confirm Lars' experience with this PMMERGE DLL. In my case I tried this with a SMP kernel, TRAP-D was the result, and so that was the end of that testing attempt on my part.

I will monitor this thread in case Lars has a different outcome.

As far as I understand, he already has a different outcome -  on SMP kernel everything is ok for him.

...
If I try the SMP kernel, it works ok. ...

Your Trap D is very welcome. Pls show trapscreen.

15
If I try the SMP kernel, it works ok. As I said, it is only a prob with the W4 kernel.

You may also try UNI kernel.

As I said, PmMerge from OS/4  does not work with "16bit system".

I have no idea what is "16bit system" from point of view PmMerge.  But code for "16bit system" is missing in it.

If it works with SMP kernel then everything as expected.

Pages: [1] 2 3 ... 24