31
Setup & Installation / Re: LVM Error Codes - Documentation?
« on: August 22, 2019, 06:49:32 pm »
Ok, I did the part -w:t -t- and it did not flag any errors. Got a bunch of warning messages about partitions after the 1023 cylinder boundary or crossing the 1023 boundary, but no errors shown.
I've got an older (V11) registered version of DFSEE. So I might go that route. But first I'm going to migrate all the partitions off the drive, wipe the drive and then try an install again.
I've got an older (V11) registered version of DFSEE. So I might go that route. But first I'm going to migrate all the partitions off the drive, wipe the drive and then try an install again.