496
Storage / Re: DISKIO - updated version in need of TEST
« on: December 20, 2020, 10:27:49 pm »
Hi David,
Hmm, interesting...so another device is causing this as well.
Can you provide the output of the run that was created before the error occured? So basically whatever are the contents of the debug.tx that was created?
The last storage device that's logged is most likely where the issue occured...some early output should still be visible, such as: disk ID, sizing, preliminary cache/bus xfer rates (if successful, etc.).
BTW and/or FYI:
The previous version of DISKIO shows the same behaviour here, so point being: this is an existing issue which I'm going to try to chase down.
Thanks!
I have the same error message.
[E:\]diskio-debug > debug.tx
SYS1808:
The process has stopped. The software diagnostic
code (exception code) is 009B.
...
I presently have no removable USB drive attached.
Hmm, interesting...so another device is causing this as well.
Can you provide the output of the run that was created before the error occured? So basically whatever are the contents of the debug.tx that was created?
The last storage device that's logged is most likely where the issue occured...some early output should still be visible, such as: disk ID, sizing, preliminary cache/bus xfer rates (if successful, etc.).
BTW and/or FYI:
The previous version of DISKIO shows the same behaviour here, so point being: this is an existing issue which I'm going to try to chase down.
Thanks!