1
Events / Re: ArcaOS 5.0.8 is out!
« on: June 03, 2023, 06:28:47 pm »
In order to upgrade is a reinstall necessary? Or is there an upgrade path for arca?
Thank You
Rick
Thank You
Rick
OS2World.com Forum is back !!!
Remember to visit OS2World at:
http://www.os2world.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Rick,
<ALT>-F1 brings up a menu when hit at the OS/2 'boot blob'.
Regards,
Great! With the viop-1.0.wpi was there something to add to autoexec.bat as well? I thought I remember something along those lines but could be wrong..
I have some notes here on the Wiki. But in my case was just installing viop-1.0.wpi and rebooting. For me that solved my problems without any other changes, but I know that on different hardware are different solutions.
Arca Noae as also some DOS-Win16 comments on their web FAQ.
If you can't make DOS Sessions work, I think your worst case scenario may be that you have to wait for ArcaOS 5.1 and enable UEFI BIOS with CSM.
Regards
Thanks Rick. I had updated the wiki.
Does everything works fine Audio, Network, All USB ports?
FYI: I guess you already known, but I got good results with " viop-1.0.wpi" for the DOS sessions.
Regards
Hi Rick
That's good.
Please post back if everything works and your PCI report (I have some instructions here).
I had created a wiki page for it here: "Intel NUC Kit D54250WYKH".
Reading the specs the only strange thing it has is the "Consumer Infrared Rx Sensor", but the rest seems that it should not give you problems, please report back.
I see the button on Firefox on ArcaOS. The only way I don't see it is if the user is not logged. (picture attached)
Back to the PCMCIA issue, I still do not have a solid clue:
I see the devices report:
Vendor 104Ch Texas Instruments
Device 8036h PCI6515 Cardbus Controller
Vendor 104Ch Texas Instruments
Device 8038h PCI6515 SmartCard Controller
And the config.sys shows this:
BASEDEV=PCMCIA.SYS /P
BASEDEV=TI1225CB.SYS
BASEDEV=AUTODRV2.SYS
DEVICE=C:\OS2\MDOS\VPCMCIA.SYS
DEVICE=C:\OS2\BOOT\PCMSSDIF.SYS
DEVICE=C:\OS2\BOOT\PCM2SRAM.SYS
DEVICE=C:\OS2\BOOT\FLSH2MTD.SYS
DEVICE=C:\OS2\BOOT\PCM2FLSH.SYS
BASEDEV=PCM2ATA.ADD /S:2 /!DM /NOBEEP
...
BASEDEV=OS2PCARD.DMD
Do you have the PC Card Director tool there? Do you see any activity, beep or anything on the PCMCIA tools that a card is inserted when you plug one?