2
« on: December 30, 2021, 10:48:35 pm »
I have iomega zip 100 with IDE interface. I want to access the disk.
I installed an additional IDE controller and drivers:
BASEDEV=DANIS506.ADD /!BIOS /A:0 /BM /U:0 /A:1 /I /V
BASEDEV=OS2AHCI.ADD
BASEDEV=DANIATAP.FLT /A:0 /U:0 /TYPE:Z /EJ /V
The system is successfully loaded.
I get a report:
R1.8.15 /!BIOS /A:0 /BM /U:0 /A:1 /I /V
Daniela's Bus Master IDE Driver for OS/2 Version 1.8.15
Controller:0 Port:D020 IRQ:10 Status:OK
JMicron JMB363 PATA host (197B:2363 rev:03) on PCI 2:0.0#1
Unit:0 Status:OK ATAPI PIO0
Model:IOMEGA ZIP 100 ATAPI 14.A
And
0/m: IOMEGA ZIP 100 ATAPI 14.A b
Port D020/D012, Irq 16, ATAPI, PIO0
0/s: (not present)
However, the drive letter in the system is not assigned and contact the device cannot be applied.
What can be done to get a drive letter in the system?
According to my memories, once a long time, this device worked in the OS / 2 system.