Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - brick

Pages: [1]
1
Setup & Installation / C0000005 error
« on: September 07, 2018, 11:34:13 am »
I"m trying to install W4.5  and I'm getting a C0000005 Error on the floppy disk install.    Any idea on its where to look?

 I  spent 4 1/2 hours trying to install v4.5 on Dell e510;  tried multiple Dani1S506 (and DaniATAPI) drivers but kept getting "unable to operate your hard disk" errors, so I switched back to the 2003 versions of IBM1S506 and IBMATAPI. Success! kind of ...     now I get to the "Loading..."  screen, but then it stops with this.
   Search brings up a few hits but none are the same as this so I'm clueless. 


 

2
Setup & Installation / bus master error
« on: July 11, 2018, 11:11:38 am »
I'm getting an error on a Warp 4.52 install on Dell e510. I updated the disks according to Alan Savage's workstation guide, but now get a bus master error after Disk 2.   What am I missing?

3
Setup & Installation / Swap on separate drive
« on: June 27, 2018, 01:26:29 pm »
I'm getting ready to install Warp 4 on a Dell e510 with 4mb ram and two 130gb drives.  Is it preferable to have the swap partition on a different drive than the OS?   It will be a dual boot WinXp/Warp4 box.  I figure drive 1 will have the os's and drive 2 will be an HFS warp swap partition and a large fat32 partition for user data and apps. 


4
Setup & Installation / moving desktop icons
« on: June 13, 2018, 08:14:50 am »
I've got a weird problem I can't seem to get a handle on and google is terrible anymore.
 Installed warp 4 on a Virtualbox 5.2.12;  updated to fixpack 15, tcpip, kernel and gradd97 drivers.  Everything works great, so I  installed a few apps.  I'm not sure when the problem began, but moving a desktop icon breaks the functionality of that program.  For example, I installed WarpIn.  It works fine. The WarpIn icon is in a WarpIN folder on the desktop. I want to reduce clutter, so I drag the Warpin Folder to Programs, the standard Desktop folder.  After that, WarpIn No longer works- I get a Cannot Start Error, Check Path and memory.  Dragging the folder back out does no good.  Delete all the WarpIn stuff by os/2 DOS window and re-install.  WarpIn Works fine til I move it, then it breaks again.  Moving it back doesnt restore function.  If I click "Find Original"  it lists the only one installed at the same location as the icon.  Clicking on the found original in the search box gives me the same error. 
This has happened on a few other programs, too. I've checked the path in the properties tab and it appears fine. 
What am I doing wrong?

Pages: [1]