1
Setup & Installation / Re: C0000005 error
« on: September 09, 2018, 11:35:02 am »
Hmm.. yep, I disabled Speedstep and the multiple cores; no effect. I seem to remember finding instructions on updating the Kernel on the disks, but haven't been able to re-find it. Still searching. Google seems to be going out of its way to not give relevant results.
Could it be the atapi or ibm1s506 drivers? Needing a switch? I hit alt-f2 and all the drivers loaded fine. It seems to crap out immediately after CD spins up and the access light flashes, like the handoff isn't established. Maybe the CD is corrupted; i"ll burn a new one and try it. I tried REMming out the RUN NPConfig.EXE; no difference. I've re-re-tried multiple dani1S506 versions (with respective DaniATAPI driver), with forced bus mode etc. Maybe I'll try it with the IBM1s506 set next.
Honey Badger Mode Activated.
Could it be the atapi or ibm1s506 drivers? Needing a switch? I hit alt-f2 and all the drivers loaded fine. It seems to crap out immediately after CD spins up and the access light flashes, like the handoff isn't established. Maybe the CD is corrupted; i"ll burn a new one and try it. I tried REMming out the RUN NPConfig.EXE; no difference. I've re-re-tried multiple dani1S506 versions (with respective DaniATAPI driver), with forced bus mode etc. Maybe I'll try it with the IBM1s506 set next.
Honey Badger Mode Activated.