Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Jan van Dijk

Pages: [1]
1
Hardware / ECS 2.0 RC 5 stops while loading OS2DASD.DMD
« on: 2008.08.07, 16:09:15 »
Hello,

The following hardware setup:
IOMega Zip 250 attached to Jmicron JMB 363 with 80 pin flatcable. Jumper set to master on the zip drive.
Zipdrive works fine under Open Suse Linux 10.3.

If I now boot ECS, the system shows Loading OS2DASD.DMD in the lower left corner (altf2on.$$$ enabled).
In case I disable the JMicron controller the system boots normally, after loading OS2DASD.DMD, it says Installed OS2LVM.DMD.
In case I change the config.sys entry BASEDEV=DANIS506.ADD /!BIOS to BASEDEV=DANIS506.ADD /!BIOS /A:2 /I, the system boots normally.
I would like to use this zip drive under ECS for backup purposes.
Can some one give me a tip on how to enable my zipdrive.

Thanks in advance,

Jan

2
Hi,

Has any one experience installing Ecomstation on an ABIT IP35 Pro motherboard.
Today I tried to install it but it failed during second reboot, you see ECS shortly in the upper left corner and after that the system reboots.
If you then startup in the maintenance console you can access the drive you installed ECS on and every thing seems OK.
I have no idea how I can find out what is wrong. I haven't found any logfile indicating what is wrong.
Can any one give me some info about what is wrong.


Pages: [1]