7
« on: 2008.07.06, 22:49:36 »
Hi,
Today I tried to install Ecomstation 2.0 RC5, but no luck, problem stays the same, immediate reboot after first reboot after installation.
I used default settings during installation, only did not do the check while formatting the HPFS partition, because this takes a lot of time.
The motherboard is brand new and contains an Intel P35 chipset with ICH9R.
Installed CPU Intel E8200
Installed Memory 2x2GB.
2x Lan RTL 8111 displayed during installation as RTL 8167
6x SATA (via ICH9R, Harddrive Seagate 500GB. connected to SATA port 1 and DVD-writer connected to port 3, DVD ROM connected to port 4.
IEEE 1394 2x.
Phoenix BIOS settings:
Onchip SATA Device:
Busmaster: Enabled.
Onchip SATA Controller: Enabled.
- SATA Mode: IDE
OnChip PCI Device:
OnChip Autio Controller: Enabled
- FP Audio: HD-Audio
USB Device Setting:
USB Functions: Enabled
- USB 2.0 Operation Mode High Speed
- USB Keyboard Support Via BIOS
- USB Mouse Support Via OS
- USB Storage Function Enabled
SuperIO Device:
Floppy Disk Controller Enabled.
Onboard PCI Device:
IEE 1394 Controller: Enabled
Network Controller 1 Enabled
-Invoke Boot Agent Disabled
Network Controller 2 Enabled
-Invoke Boot Agent Disabled
Storage Controller Enabled
-SATA Mode IDE
Power Management Setup
ACPI Suspend Type: S1 (PowerOn-Suspend) (Choises are S1 and S3)
x - Resume by USB from S3: Enabled, Can be disabled using S3.
Power Button Function: Instant-Off
Wake Up by.... all Disabled.
Power On By PS2 KB/MS: Disabled
Restore on AC Power Loss: Power Off.
Advanced Chipset Features:
DRAM Timing Selectable: By SPD
PCIe Compliancy Mode v1.0a (selection possible: v1.0a and v1.0)
PEG Force X1: Disabled
Init Display First: PCI Slot
Attached find a zip file showing the output of some acpi utilities I ran from the maintenance console:
acpitree.log containing the output of acpitree.
acpiirq0.log containing the output of acpiirq 0
acpiirq1.log containing the output of acpiirq 1
scanpci.log containing the output of scanpci
also included the config.sys for investigation, I have no idea how to see if acpi is enabled, I see some acpi statements in config.sys but don't know if this is correct.
I don't know if the correct kernel is installed but the current date of os2krnl is 5-01-07 2:16p, size 849262.
Hope some one can help me to find out what is the problem here.
Best regards,
Jan van Dijk