76
This is an old OS2World backup forum for reference only. IT IS READ ONLY!!!
If you need help with OS/2 - eComStation visit http://www.os2world.com/forum
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
OK, I found what the problem is. I tested to see if this is the same problem I have had before and it is. It must have been related to the unikrnl when I tested it before. However, at the time, I did not put 2 + 2=4 together.
I have a WIFI and a network card.
The WIFI is a GenMac Wrapper Intel 2200 Wlan.
The network card is an Realtek 8139/8130/810x.
Although the WIFI driver is supposedly supported, installs, and loads with eCS 2 rc4, I have never been able to access the internet wirelessly.
The Realtek card driver has always worked.
With the old os2krnl, it did not matter that both drivers are installed. With the unikrnl, it does matter. By removing the GenMac driver, I now can access the internet with the Realtek ethernet card driver.
It's set at 12.5 x 166. The board has worked fine for years, save for adding memory.
I couldn't find usbdock in the betazone on the eCS site. Resource manager didn't run from usbcfg.
I brought up LVM. It found the drive, D3, listed as O: (my last partition is M:). I tried to follow the instructions here, and give it the name "External", but I don't think it took (and I hope I didn't mess anything up.)
Please try 104a UNI instead of W4
http://www.ecomstation.org/sidebars/cmd/kernel/files/uni20050811.zip
Well, I got further this time. Last time I could not get past the eCS logo. I am booting further, however, I am now Exception in module: JFS which is a trap D.
Unfortunately I am going out of town for a week and won't have the time to take a picture and upload it here right now.
David