Hi
I installed ecs 2.0 rc7 on a hpfs partition from the CD. The machine is a Compaq Presario CQ70 laptop.
Here it is a wiki page I created about that laptop.
http://www.os2world.com/wiki/index.php/HP_Compaq_Presario_CQ70It installs ok, without any network adapter (No network adapter is selected).
I did an standard installation with the default stuff to install. Didn't add or remove anything from the installation list. It finished installation process without problems.
It boots fine the first time. - I close the Post-Installation Task Window.
It boots fine the second time. - I close the feedback wizard.
Third time boots fine. - Switched the volume to 40, since 100% was annoying. - Shows me the I changed the Panorama driver resoluton to 1400xxxx. I also installed GenMAc to make some tests trying to get Atheros
Them it keep booting fine, but in some point of time which I haven't found, when I boot I get the following Message.
SYS0193:PMMERGE can not be run in a OS/2 Session.
SYS1919: The file PMMERGE specified in the RUN statement
on line 204 of the CONFIG.SYS file does not contain a valid program.
Line 204 is ignored
Press Enter to Continue...When it reach to PMSHELL. It shows this message, beeps and freeze.
The file PMMERGE specified in the PROTSHELL statement on
line 130 of the CONFIG.SYS file does not contain a valid program.
Line 130 is ignores
The system is stopped. Correct the preciding error and
restart the system.I can not found where is the problem. Since I had also tested removing Uniaud, ACPI, Genmac. But I can not which driver is causing eCS to hang. Or what is the problem.
So there are two thing I need to find:
1) What is causing the problem.
2) Find out how to fix an installation that had this error, since the only way I had found to fix it is to reinstall it again, which after some time it breaks again with this error.
Any hint is welcome.
Thanks.