Green motherboard does not boot: Difference between revisions
mNo edit summary |
No edit summary |
||
(3 intermediate revisions by 3 users not shown) | |||
Line 1: | Line 1: | ||
Return to [[The | Return to [[The Hardware Shelf]] | ||
Last update: 10th February, 1996 | Last update: 10th February, 1996 | ||
Line 13: | Line 13: | ||
== Procedure == | == Procedure == | ||
I don't know if this will end up helping anyone out there but I have recently upgraded my motherboard to a generic green VLB 486 board and found that Warp would not boot unless I disabled the external cache. | I don't know if this will end up helping anyone out there but I have recently upgraded my motherboard to a generic green VLB 486 board and found that Warp would not boot unless I disabled the external cache. I didn't like that solution so I started playing around with the settings (quite blindly) and discovered that setting the waits states to their highest setting (3) on the external cache allowed it to boot, but it would usually hard lock after a few moments of use. Then I set the Local Ready delay to 1T (from 0t) and have not crashed since. | ||
Note: I found that it was also necessary to switch the chipset Auto-config option off... it must not like the auto-config very well. | Note: I found that it was also necessary to switch the chipset Auto-config option off... it must not like the auto-config very well. | ||
Line 19: | Line 19: | ||
By Walter Tallent | By Walter Tallent | ||
Return to [[The | Return to [[The Hardware Shelf]] | ||
[[Category:The Warp Pharmacy]] | [[Category:The Warp Pharmacy]] |
Latest revision as of 17:04, 22 December 2024
Return to The Hardware Shelf
Last update: 10th February, 1996
Symptoms
Warp does not boot
Hardware
Green VLB 486 board with AMI BIOS 7-02-95
Problem
Unknown.
Procedure
I don't know if this will end up helping anyone out there but I have recently upgraded my motherboard to a generic green VLB 486 board and found that Warp would not boot unless I disabled the external cache. I didn't like that solution so I started playing around with the settings (quite blindly) and discovered that setting the waits states to their highest setting (3) on the external cache allowed it to boot, but it would usually hard lock after a few moments of use. Then I set the Local Ready delay to 1T (from 0t) and have not crashed since.
Note: I found that it was also necessary to switch the chipset Auto-config option off... it must not like the auto-config very well.
By Walter Tallent
Return to The Hardware Shelf