OS/2 Warp and NEC CDR-271 CDROM: Difference between revisions

From OS2World.Com Wiki
Jump to navigation Jump to search
Created page with " Last update: 6th November, 1995 ---- I recently had a lot of trouble getting an NEC CDR-271 CDROM to work under Warp. This is an IDE CDROM and the only IDE device on the mac..."
 
Ak120 (talk | contribs)
mNo edit summary
Line 1: Line 1:
Last update: 6th November, 1995
Last update: 6th November, 1995


----
I recently had a lot of trouble getting an NEC CDR-271 CDROM to work under Warp. This is an IDE CDROM and the only IDE device on the machine (the hard disk is SCSI). It worked fine under DOS.
I recently had a lot of trouble getting an NEC CDR-271 CDROM to work under
Warp. This is an IDE CDROM and the only IDE device on the machine (the hard
disk is SCSI). It worked fine under DOS.
 
I installed the latest ATAPI drivers, as per the instructions for NEC drives,
and the symptom was that the machine would pause on bootup trying to reset the
CDROM drive, with the BUSY light flashing. After about a minute it reported
an error, before continuing to boot.
 


The cure was to move the CDROM drive from the primary to the secondary IDE
I installed the latest ATAPI drivers, as per the instructions for NEC drives, and the symptom was that the machine would pause on bootup trying to reset the CDROM drive, with the BUSY light flashing. After about a minute it reported an error, before continuing to boot.
adapter. It must also be installed as the master drive since there is no
other SCSI device in the machine. DOS didn't care which IDE port it was on,
but for some reason OS/2 did, so moving it cured the problem.


The cure was to move the CDROM drive from the primary to the secondary IDE adapter. It must also be installed as the master drive since there is no other SCSI device in the machine. DOS didn't care which IDE port it was on, but for some reason OS/2 did, so moving it cured the problem.


----
''John Krivitsky''
[[John Krivitsky]]


[[Category:The Warp Pharmacy]]
[[Category:The Warp Pharmacy]]

Revision as of 19:07, 30 May 2017

Last update: 6th November, 1995

I recently had a lot of trouble getting an NEC CDR-271 CDROM to work under Warp. This is an IDE CDROM and the only IDE device on the machine (the hard disk is SCSI). It worked fine under DOS.

I installed the latest ATAPI drivers, as per the instructions for NEC drives, and the symptom was that the machine would pause on bootup trying to reset the CDROM drive, with the BUSY light flashing. After about a minute it reported an error, before continuing to boot.

The cure was to move the CDROM drive from the primary to the secondary IDE adapter. It must also be installed as the master drive since there is no other SCSI device in the machine. DOS didn't care which IDE port it was on, but for some reason OS/2 did, so moving it cured the problem.

John Krivitsky