Daniela Engert released new versions of her (E)IDE/ATAPI drivers.
DaniATAPI.FLT (a generic ATAPI Filter) has been updated to release 0.3.2.
This filter driver supports all types of ATAPI devices. It is a superset of IBMIDECD.FLT, IBMATAPI.FLT and DaniADsk.FLT, and supports all
devices that the mentioned drivers do.
Additionally, all ATAPI devices can be accessed through the OS/2 ASPI software interface. Each EIDE channel shows up as a SCSI channel, and
each ATAPI device as a SCSI device (master = SCSI ID 0, slave = SCSI ID 1).
DaniS506.ADD (replacement for IBM1S506.ADD) is now available in release 1.3.3:
EIDE driver with support for Intel, VIA, ALi, SiS, CMD, Promise, Cyrix, HighPoint and AMD chipsets, and generic busmaster support for all
SFF-8038i compliant chips.
This covers virtually *any* EIDE controller built/sold in the past few years and even some just about to be released in the near future. Don't be
confused by the generic chip names below! If you are uncertain about your actual controller to be supported, run the DumpIDE utility - it will tell
you.
->http://hobbes.nmsu.edu/cgi-bin/h-search?key=dani
Source: OS/2 ORG